Diagnostics
Print fixes and calibration
Three procedures for a printer you already have. Each one starts with the cheapest safe check, changes one variable, and says what the next reprint should do. Buying a plate, a glue, or a dryer comes after that log, on the existing scorecards.
Not a ranking, and not a materials overview
Printer rankings live on the buyer guides. PLA vs PETG answers which scored printer fits the material. This hub does not pick a winner and it does not publish a strength chart.
Temperatures on the drying and stringing pages are copied from Prusa or Bambu and named by grade, printer, plate, or dryer. Where those pages disagree, both figures stay. This site did not run the prints those numbers come from.
Start from the symptom
First layer
3D Print Not Sticking to the Bed
The part will not stay down, or it will not come off.
First check: Name the plate, then use only the cleaner that maker documents for that sheet.
Name the plate before you wash it. Prusa and Bambu do not share a cleaner, and PETG on smooth PEI can be stuck too well, not too little.
PETG stringing
PETG Stringing: A Controlled Checklist
PETG leaves hairs or blobs between parts.
First check: Dry that grade, then change one setting from that printer's own profile.
Hairs between parts are a symptom, not a retraction preset. Dry the grade you actually loaded, then change one setting from that machine's own profile.
Filament drying
How to Dry Filament (PETG, TPU, PLA)
A spool may be wet, or you need a temperature before you heat it.
First check: Match the grade and the dryer. Do not average Prusa and Bambu.
Match the grade to the dryer and the spool. Where Prusa and Bambu disagree, both figures stay on the page. A kitchen oven is not the default.
How to use a page
- Write down the printer, the plate or the spool, and the profile that is loaded.
- Do the cheapest safe check that matches that hardware. Do not enclose an A1, and do not start with a kitchen oven.
- Reprint the same small part. If the expected result is missing, undo the change before you try the next one.
- Open the maker's support path when the documented checks are exhausted. The source list on each page says which document the number came from.